Pulmonary Aeration and Muscle Thickening Fraction: Association of Electrical Impedance Tomography and Ultrasound

OBJECTIVES Main Objective To evaluate, in infants with respiratory failure secondary to bronchiolitis, the effect of different High Flow Nasal Cannula (HFNC) flow rates on diaphragm, rectoabdominal, and oblique thickening fraction, and to determine whether this effect depends on the action of HFNC flow rates on Functional Residual Capacity (FRC).

Secondary Objectives

• To evaluate whether there is a correlation between thickening fraction and respiratory distress score.

• To find values from the EIT data and the thickening fraction that can correlate with possible failure criteria for HFNC therapy.

  5. METHODS 5.1 Study Type and Location A prospective clinical study will be conducted in the Pediatric ICU of Hospital Israelite Albert Einstein from January 2024 to December 2025 5.2 Ethical Aspects This study will be submitted to the Ethics and Research Committee of the Hospital Israelite Albert Einstein. The risk of participating in this research is considered minimal, limited to the accidental loss of confidentiality of the data collected or to skin erythema at the site of application of the belt. Only after signing the informed consent form will the patient be prepared for the beginning of monitoring (Appendix 1) Protocol The tape will be installed around the chest before the start of the change in flow rates and monitoring with EIT will be initiated. Patients will be positioned in dorsal decubitus elevated 10 to 20 degrees and monitoring will be performed continuously during all flow rate variations and also during the ultrasound performance.

Four different randomized flow rates will be used for evaluation: 2.0 liter.Kg-1.min-1, 1.5 liter.Kg-1.min-1, 1.0 liter.Kg-1.min-1, 0.5 liter.Kg-1.min-1. At the end of the randomized order evaluation the infant will remain in the flow of 0.5 liter.Kg-1.min-1 for 5 minutes and then return to the flow of 2.0 liter.Kg-1.min-1. The EIT parameters, ultrasound assessment, and clinical variables will be collected at the end of the 5-minute stay in each lane.

5.5 Randomization: Randomization process The sequence of the flow values will be done using a tool software R 5.6 Clinical and demographic variables Demographic variables such as age, sex, Pediatric Index of Mortality Score (PIM2) (23) and viral screening will be collected when requested during routine hospitalization.

Of the clinical variables, respiratory rate (RR) will be assessed by counting the inspiratory cycles produced by EIT plethysmography in one minute. Heart rate (HR) and peripheral oxygen saturation (SpO2) will be obtained directly from the Infinity Delta multiparameter monitor (Dräger, Lubeck, Germany). Inspired oxygen fraction (FiO2). The Respiratory and Oxygenation Index (ROX index) will also be calculated, which is calculated by the ratio of SpO2/FiO2 by RR.

To evaluate respiratory distress, the investigators will use the respiratory distress score.

Electrical Impedance Tomography The recording of the electrical impedance variation over time is called plethysmogram and this provides information on the ventilation variation which is called Delta Z (∆Z) and has an excellent correlation with the volume variation assessed by computed tomography (25) and the minimum impedance (ZMIN) or ∆EELZ (end-expiration lung impedance) which is the baseline of the plethysmogram and corresponds to the FRC (26,27).

The unit of measurement commonly used to quantify changes in impedance amplitude is arbitrary unit (AU).The average of at least 5 sequential respiratory cycles for each patient, in each flow range, will be considered for evaluation, considering the moment of greatest stability within the final minute of the flow rate to be evaluated. Calculations to obtain delta Z were performed by subtracting the final moment of inspiration from the final moment of expiration. The changes in EELZ (∆EELZ) will be compared to the average EELZ at a flow rate of 0.5 L-kg-1-min-1 (reference flow rate). Therefore, by definition, the average ∆EELZ at the 0.5 L-kg-1-min-1 flow rate will be equal to zero. To obtain clinically meaningful values instead of AU values, the ∆EELZ will be normalized by the corresponding Delta Z at the reference flow rate (28). With this transformation, ∆EELZ can be interpreted as changes in lung aeration measured in multiples of Delta Z (tidal volumes). For example, if an infant has a mean Delta Z of 15 AU at flow rate of 0.5 L-kg-1-min-1, a ∆EELZ of 30 AU at flow rate of 2.0 L-kg-1-min-1 will be shown as 2 (an increase in lung volume twice the Delta Z at the reference flow rate).

Evaluation by ultrasound Serial measurements of thickness and thickening fraction of the diaphragm and abdominal muscle (rectus and oblique) will be collected through ultrasound images by previously trained staff. The images will be taken in the SonoSite M-Turbo® device, using an L25x (13-6 MHz) linear transducer. Heated water-based gel will be used for image acquisition.

For the diaphragm thickness measurements, the investigators used right hemidiaphragm with the linear transducer located between the anterior and middle axillary lines around the ninth intercostal space, in the diaphragmatic apposition zone (29,30). For the rectus abdominis thickness measurements the investigators used the linear transducer positioned 2 cm to the right and 2 cm above the umbilical scar. The external oblique, internal oblique and transverse muscles of the abdomen can be identified as three parallel layers, usually best visualized on the anterior axillary line, midway between the lower edge of the rib cage and the iliac crest (15,16) The window will be obtained in B-moded, and the measurement performed in M-mode. For the measurement of the thickening fraction, the investigators will use the formula ((Eins - Eex) /Ex) x 100), where Eins = thickness obtained at the end of inspiration and Eex = thickness obtained at the end of expiration.