Local Anaesthetic Spread and Sensory Block Range of the Retro-superior Costotransverse Ligament Space Block

Fifty patients were selected to undergo CT guided puncture localization of lung nodules under local anesthesia, and the patients were divided into groups using a computer-generated random number in a ratio of 1:1. To ensure objectivity, a nurse who was not involved in the study prepared a sealed opaque envelope containing grouping information. Patients were randomly divided into two groups: the retro-SCTLB group (group R, 25 patients), and the TPVB group (group T, 25 patients). All patients underwent ultrasound guided retro-SCTLB or TPVB before CT-guided nodule localization. Ultrasound-guided retro-SCTLB method: Using an ultrasound low-frequency convex array probe (1-6 MHZ, Sonosite, USA), the probe was placed parallel to the spine 2-3cm outside the spinous process of the fifth thoracic vertebra, on the surface of the transverse process tip. First, the probe was placed above the rib and costo-transverse process joint and observed from the inside out to clearly show the spinous process, lamina, transverse process and rib. Then, the probe was gently moved towards the caudal side. Until the sound shadows of the ribs and transverse processes disappear and inferior articular processes appear on the medial side, and when high-echo superior ligaments of the costal transverse processes appear behind the paravertebral space and anterolateral of the inferior articular processes, then gently rotate the outer edge of the probe towards the caudal side and a low-echo area can be seen behind the superior ligaments of the costal transverse processes, which is the target area. Then, using a long oblique plane puncture needle, with the in-plane technique, insert the needle from the outer side of the probe. When the needle tip reaches the target area, use the water separation technique to inject 1ml of normal saline to confirm the needle tip position, then inject 20ml of local anesthetic solution (0.375% ropivacaine 10ml+ iohexol 10ml) within 1 minute; Ultrasound-guided TPVB: Using an ultrasound low-frequency convex array probe (1-6 MHZ, Sonosite, USA), the probe is placed perpendicularly to the spine at the fifth thoracic vertebra on the midline of the trunk. First, the spinous process is identified, and then the ultrasound probe is gradually moved towards the surgical side. Structures such as the transverse process, pleura, and intercostal intima are visible. At this point, the ultrasound probe is moved parallel to the caudal side. The area between the parietal pleura, intercostal endometrium and transverse process is the target area for injection. Then, using a short inclined plane puncture needle, using the in-plane technique, the needle is inserted from the outside of the probe. When the needle tip reaches the target position, 1ml of normal saline is injected using the water separation technique to confirm the needle tip position. Then 20ml of local anesthetic solution (0.375% ropivacaine 10ml+ iohexol 10ml) is injected, and the injection is completed in 1 minute. 15 minutes after the block was completed, CT scans were performed and punctures were located, followed by three-dimensional reconstruction. Observe and record the local anesthetic solution: 1. The range of diffusion to the cranial and caudal side; 2 The range of diffusion to the intercostal space 3; The range of diffusion to the paravertebral space; 4. The range of diffusion to the epidural space; 5. The range of diffusion to the intervertebral foramen; 6. The range of diffusion to the anterolateral vertebrae (sympathetic ganglion).